Tabitha Libby asked 2 months ago
Peugeot 208 key replacement is best left to auto locksmiths with experience who have the appropriate tools and know-how. They can make and program new keys faster than a dealership would and at a lower price.
If your key fob has stopped locking or unlocking your doors, it is likely due to a dead battery in the coin. But, there are other reasons that the key may be malfunctioning.
Dead Coin Battery
A dead coin battery can stop your Peugeot 208 from locking or unlocking and peugeot 208 Key replacement cannot start the engine. In this instance, you will need to choose the alternate method to start described in your vehicle owner’s manual.
The spark plugs might also be worn out. The spark plugs ignite the fuel to start the engine. However, they have a limited lifespan. If they aren’t used enough to last, they’ll eventually fail.
Luckily, there is an easy solution to this issue. Verify the voltage of your battery using a multimeter. If the voltage is below 11,5 volts, it’s time to replace it. If the battery has corroded it is essential to clean its contacts. This can be done by lifting the rubber covers covering the two battery terminals and using wire brushes to clean any corroded components of the battery. You should then reconnect the cables to the positive and negative poles.
Water Damage
If your 208 won’t start and the battery isn’t empty, you must ensure whether the spark plugs work. You might find that they are dirty and they don’t spark. The spark plugs can be cleaned in an workshop.
Peugeot automobiles are equipped with a transponder that is compatible with the immobiliser. This ensures only the correct key can turn the engine. If the chip inside the Peugeot key is damaged, then it will not send the proper signal to the vehicle.
This is a typical issue that can be caused by water damage. This is a common issue in colder climates where the vehicle has been exposed to snow or rain. In this case, you need to contact a reputable locksmith who has the tools and peugeot 208 Key replacement equipment required to modify the key. They will also have all the latest technology and machinery needed to make a peugeot replacement key fob smart key. The process shouldn’t be more than 15 minutes.
Contacts for the battery that are defective
Peugeot changed from the carbon-encased transponder chips to an entirely new key for peugeot 207 type of chip that uses electronic components in a circuit board. This new technology works great when it’s fresh, but over time the circuit boards start to wear out and stop functioning properly.
This could prevent the immobiliser chip activating and causing your car to not start. If this happens it’s a good idea to call a Peugeot specialist or locksmith.
Another common issue is when the battery of the key fob begins to fail, which causes the blade of the key to stop from entering the lock. A locksmith in your car will replace the battery, and cut a new blade for you. This is a simple fix.
Faulty Receiver Module
It could be that the receiver module is defective in the event that your Peugeot key fob fails to function after being dropped on the floor, or exposed to a sudden storm or accidentally washed. The receiver is responsible for transmitting radio frequency signals to an on-board computer, which controls the central locking system in your Peugeot vehicle.
The key fob itself is fitted with rubber seals that prevent water from getting to the chip inside. However prolonged exposure to water may penetrate these seals and damage the chip. The high salt content of the pool or ocean water can cause damage to the key fob when it is submerged.
The module must be replaced if the Peugeot spare key isn’t working anymore. This should be done by a Peugeot specialist or an expert auto locksmith. Like other automobiles, Peugeot keys are protected by an unique immobilizer system that requires the correct coding in order to start the engine. This is why it is imperative that you should only trust a Peugeot locksmith to create and program an alternative.
Computers with faulty on-board computers
The on-board computer in your Peugeot is responsible for a variety of the systems in the car, from power windows to airbags. When something goes wrong with these systems, it will typically display a code indicating the issue. The code is stored within the system and will remain there until the issue is solved. Usually, this will mean replacing the computer on board.
One of the most frequent causes of the light turning on is loose or corroded connectors in the airbag sensor. This could be due to wear and tear, aging, or exposure to moisture and salt. It is important to have this issue addressed as quickly as you can, since the airbag malfunctioning could be dangerous in the event of an accident.
If you notice a card not found error on your Peugeot key fob, the battery inside the key fob may be dead or weak. This will stop the key fob from sending a signal to disarm your vehicle’s immobilizer. Try this by pressing the unlock button on the fob’s key, then trying to start your car. If this does not work, then the key battery needs to be replaced.